Can-Am Maverick Forum banner

41 - 60 of 87 Posts

·
Official Site Vendor
Joined
·
525 Posts
Discussion Starter #46
I should be all powder coated with a Rigid 50" Single row and LED Lightbar, 2 Lighted Whips, 2 Way Radio, Seats and Harnesses, Roof and some other UTVinc Goodies By 5 pm if the World dont end sooner
 

·
Registered
Joined
·
6,621 Posts
Is that cage made with 2" or did you go down to 1 3/4"? DOM or CM?
Are you going to add the front cross bar & intrusion bars?
Is it lower than the stock cage? if so how much? 3" or 4" maybe?
That is what I have envisioned for mine.
Looks really good with the slight radius also.
Sweet.
 

·
Registered
Joined
·
6,621 Posts

·
Official Site Vendor
Joined
·
525 Posts
Discussion Starter #51
Tes I did 2" DOM and yes Twisted seats and I had to make new seat latch releases for them so I could get the seat far enough back and I shit canned the seat slider
 

·
Registered
Joined
·
6,621 Posts
Tes I did 2" DOM and yes Twisted seats and I had to make new seat latch releases for them so I could get the seat far enough back and I shit canned the seat slider
Yeah I will also need to figure out how to move the drivers seat back a little.I also want to tilt it back just a little bit.
Can you post a picture of your seat latch set up?
 

·
Registered
Joined
·
3,127 Posts
I looked at the seat mount, and you'd need to cut off the top part of the latch. Then you'd need to clearance the bottom of the seat bracket. Then just drill 4 new holes and move it back. The 4 holes is easy. The clearancing, not so much! But if you take your time, I think it will work.
 

·
Registered
Joined
·
5,752 Posts
41 - 60 of 87 Posts
Top