Can-Am Maverick Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Just got myself a 2020 Trail 1000 DPS- YAY! I tend to push on the hard side and get stuck every once in a while, so I don't ATV without a winch. I am going to pick one up and install it this weekend, my question is on the wiring. I see the wiring block under the dash with the three studs, and from what I've found these are Accessory, Hot, and Ground. First...is this true? And second, can I connect directly to these studs for the power to winch? Or do I need to run all the way to the battery? Any input would be appreciated.
 

·
Registered
Joined
·
89 Posts
I used the studs on the wiring block like you mentioned. Ran the power from the block to the solenoid then power to the winch. I used Can Am harness #715003777 made it plug and play.
 
1 - 4 of 4 Posts
Top