Yesterday I installed the CT Race Worx lower a arms and Keller ball joints. I've got to say these things are pure badassery and cannot wait to punish them this weekend. What did you do?
Wouldn't be a secret if I told you would it? Besides I will more than likely sell off the idea and drawings once its proven for someone else to manufacturer and sell. Its a lot more fun designing and prototyping than it is to manufacturer and retail parts.
Thanks. I am hoping to make it to Glamis this weekend, but a monkey wrench has been thrown in to said plans. I am anxious to try out this set up along with Ed's suspension work in the sand. Oh and the Dynojet tune in the sand too. LOL!
Morning all. Wanted to start a thread and give a shout out to FEDEX/UPS/USPS. Since being shut in I have added a lot of parts to my X3 and I wanted to see if anybody else has done the same:
1. Fenders from RMATV
2. Lower Bags from CAN AM via RMATV
3. Rugged radio pumper system and helmets...
I was riding with Dustin from S3 Powersports at Red Creek Off Road this weekend and he was in his monster Blue MAV. We were on a MUDDY trail when he pegged the throttle in 4WD on a ramp and the rear driveshaft exploded knocking a hole in the Transmission. No biggy, he drove back to the Trailer...
Is there a way to get from the Prescott, AZ area to the Grand Canyon? I’ve been told that a group did the trip but couldn’t find any info on what route they would have taken. Has anyone done this?
I posted this in the introduction forum as it was my first post. Hoping to get a little more eye traffic here. Bear with me it is a long post but I hope I can get some good insight. Thanks in advance.
Hello everyone, been reading on this forum for quite a while and have been picking up...
A forum community dedicated to Can-Am Maverick owners and enthusiasts. Come join the discussion about performance, accessories, modifications, troubleshooting, maintenance, and more!
DandTX3RC · updated 
SlowRollCrawlin · updated 
Explitplayer · updated 
