Can-Am Maverick Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter #1
Okay so I got the warn vantage 4000 today and have a few questions as I have searched the forums and still need a little help. So I can use the factory wiring that’s on my 2014 maverick for plug and play right? If that is the case how do I wire in the remote control plug and where would I install it as I want to be able to use the remote. I installed the control box up by the air box and ran the blue & yellow wires back to the battery so the factory wiring will plug into the dash switch and controller right? Thanks for any help
 

·
Registered
Joined
·
1,059 Posts
Search around there are some good threads on this, but basically all the wiring you need is in there.

The three small wires for your controller are under front plastic near passenger headlight, the green plug behind your switch panel is for your rocker switch, and the wired remote utilizes the three prong plug in the same location then the wires remote plug mounts in glove box.
 
1 - 3 of 3 Posts
Top