Can-Am Maverick Forum banner
1 - 2 of 2 Posts

791 Posts
Discussion Starter · #1 ·
I have a custom UTV Inc switch that I use to switch a few of my accessories such as halo's and lighted whips. It has worked well but recently I was having some trouble with the switch cover light going dim, so I did some testing and found I have some voltage going to ground. This is also causing my 12V out to only be approx. 2.5 volts because of the bad ground I would assume.

Any ideas what might be going on or how to fix it?

Helicopter Yellow Rotorcraft Helicopter rotor Vehicle
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.