Can-Am Maverick Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,319 Posts
Discussion Starter · #1 ·
I was removing the clutch cover to install my new clutch today using my new favorite tool(well its about a month old) and decided why not angle drill my Factory UTV UHMW skid so I can get my wobble socket & extension to the lower CVT cover bolts instead of using a ratchet wrench. Figure I can throw my Snap On elec ratchet in my RotoPax tool box and zip this off in a matter of minutes on the trail if I need to & not have to deal with the hot exhaust pipe. I just angle drilled a 1/2" hole & the wobble socket & extension slide right in perfect position.
Impact wrench Impact driver Blow torch Muffler Rotary tool
Floor Tool
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top