Can-Am Maverick Forum banner
1 - 9 of 9 Posts

·
Premium Member
Joined
·
14,116 Posts
Time for aftermarket!
 

·
Registered
Joined
·
4,223 Posts
Another damn tree causing havoc......

Question, would a CT raceworx have held up to the impact?
If so, wouldn't something else become damaged more serious if it did? Always wanted to hear what people have found.
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #8 ·
It wasn’t that hard of an impact to the tree I’m sure any aftermarket arm would of been fine. The back part of the arm wasn’t even bent. That much till the ride back to camp. Every bump made it bend more.
 

·
Registered
Joined
·
12 Posts
Similar thing happened to me only 4 hours on the machine, clipped a tree going about 5mph and my right lower a-arm bent just like yours. After reading countless posts by others with similar stories I installed CT Raceworx lower a-arms and their gusset kit. It isn’t a fun install, but may as well do both since you’ll have the car apart anyways.
 
1 - 9 of 9 Posts
Top