Can-Am Maverick Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
206 Posts
Discussion Starter #1 (Edited)
holes in cage

Anyone think that drilling a few small holes (5/16) in cage for purpose of routing lights thru compromise the structure? Have seen on some sites that it doesn't at all and other say be strategic where you position the holes. Installing lights and don't want to run wires on outside of cage
 

·
Registered
Joined
·
4,536 Posts
yes u will be fine tons and tons drill holes, its also a 2'' cage lil better then all the rest with 1.75 , just don't drill close to a bend

don't drill 2-3 holes close or in a row , but 1 here and there is ok , hell if u want u can weld a washer to support the hole if ur worried !
 

·
Hickory, NC
Joined
·
2,958 Posts
Paint the kerf, Squirt a lil foam sealer in there before you put your grommet in and also think about using a piece of 7 wire SO cable for future wires... Reverse light, xtra speaker, whatever
 
1 - 3 of 3 Posts
Top