Can-Am Maverick Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter #1
I was curious if anyone knew ,or could check their take off factory tie rods for the approximate thread depth .Thanx guys. I'm sure you know what I'm up to....
 

·
Registered
Joined
·
4,536 Posts
stock is 2'' of threads maybe 1 7/8
 

·
Registered
Joined
·
58 Posts
Discussion Starter #3
Thanx Benzo ... Do you think either end uses that much thread? I know you need adjustment but are the ends anywhere near that lenth?
 

·
Registered
Joined
·
6,621 Posts
If your making your own why just remove your stock ones and copy them?
 

·
Registered
Joined
·
4,536 Posts
Thanx Benzo ... Do you think either end uses that much thread? I know you need adjustment but are the ends anywhere near that lenth?
ya when u remove urs u can see how long the rods are going in , there a good 1.5 long I thought
 

·
Registered
Joined
·
58 Posts
Discussion Starter #6
Yeah , that's prolly gonna happen anyway. I was gonna be riding this weekend and wanted to get the thread depth when the aluminum stock shows up Monday to send to machine shop. I know the drill and tap size but I didn't want to go too deep. I figured it would make the ends weak because I'm leaving the rods solid , not gonna hollow them out... Thanx for the info.
 
1 - 6 of 6 Posts
Top