Can-Am Maverick Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
I have a full STM rage 3 setup. Gold springs in both, 45 Helix, 2 shims, 40 gram arms, 11/2/0 weight set up. I ride mainly Ocotillo and hardback. On the street, from a rolling start, WOT, RPM's go to 7950, then drop to 7300 and start to climb again. I thought the RPM's were supposed to stay in one place at WOT? Don't these cars like it right around 7700? Maybe the belt is slipping? Thanks for your help.
 

·
Registered
Joined
·
1,159 Posts
Start by putting two tungstens in each weight, one on each side, up next to the pin. No weight anywhere else, see what that does.
 

·
Registered
Joined
·
791 Posts
Your weights sound about right for those springs and helix. Might be something wrong. If Mr.RPM's suggestion yields similar results I would take your belt off and your primary spring out and see if your primary shifts in and out smoothly by hand. It should not hang at all…..
 
1 - 5 of 5 Posts
Top