Can-Am Maverick Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
394 Posts
Discussion Starter #1
Hey guys, instead of pestering Kris today I figured I'd ask here. I'm replacing my helix and need to know the torque on the little allen screws? Also, while I was cleaning the assembly the fiber washers fell off. They go between the pulley halfs right? There were two.
 

·
Vendor
Joined
·
6,220 Posts
I would guess torque for something like that to be about 7-10 ft pounds Max. They lock tight them as well.
 

·
Registered
Joined
·
272 Posts
Yes the two fiber shims go In between the inner and outer sheave.
 

·
Registered
Joined
·
394 Posts
Discussion Starter #4
Ok guys thanks!!
 

·
Registered
Joined
·
7,381 Posts
make sure you put the short screws in the far right side holes in all 3 locations so you don't damage your rollers…..
 

·
Registered
Joined
·
394 Posts
Discussion Starter #6
Thanks heavy. I got er together last night. The RPM is still a little high. I'll add some weight tonight and try it again.
 

·
Registered
Joined
·
7,381 Posts
what RPM are you seeing and under what conditions?
 
1 - 7 of 7 Posts
Top