Can-Am Maverick Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
128 Posts
Discussion Starter #1 (Edited)
putting something together and just want to know a couple things, need to know the measurement from the center of the rear chassis bar to the floor (see pic) and how many miles your unit has on it if that's not much to ask? only if you have not messed with your spring pre load and its at the factory set heights
thanks in advance

you can see in this case it is 12 and 3/4 inches

 

·
Registered
Joined
·
545 Posts
28.4 miles, 2.2 hrs, no adjustments yet, driven at beach, trails, whoops. Sitting at 13.5"
UPDATE - stock wheels & tires, 14psi, level concrete floor, Stanley tape measure, 48 degrees, barn lights on ...
 

·
Registered
Joined
·
128 Posts
Discussion Starter #4
didnt think of that sometimes forget people get carried away with rims lol stock rims and tires PSI didnt make enough difference to measure with ours, 10 or 15 it was the same
 

·
Registered
Joined
·
4,536 Posts
also is that dirt level ???

or low spot in center
 

·
Registered
Joined
·
128 Posts
Discussion Starter #6
I though it was a simple enough question lol ride height from the ground to the center of the bar. On level ground. With stock wheels and tires.
 

·
Registered
Joined
·
232 Posts
28.4 miles, 2.2 hrs, no adjustments yet, driven at beach, trails, whoops. Sitting at 13.5"
UPDATE - stock wheels & tires, 14psi, level concrete floor, Stanley tape measure, 48 degrees, barn lights on ...
What was the moon phase? Might be affected by tides..... LOL :big smile:
 

·
Registered
Joined
·
6,621 Posts
mine was 13" from the factory, but it also had 18lbs of air pressure.
 

·
Registered
Joined
·
1,103 Posts
1 - 10 of 10 Posts
Top