Can-Am Maverick Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,113 Posts
Discussion Starter #1
Want to change the shifter knob but not sure if it is threaded on and if it is is it metric or standard thread? I want a T-handle like a hurst shifter T-handle. I seen some custom pistol grip ones but I don't like the pistol grip look. If any body know if its threaded or if it has a set screw would be appreciated.
 

·
Registered
Joined
·
175 Posts
Its Threaded loosen the stop nut and it comes off, its hard the hole way so it will give your wrist a work out. As far as the thread size don't know that however it will use any Can Am shifter knob.
 

·
Registered
Joined
·
6,621 Posts
Once you get it removed you should be able to figure out the threads .
 

·
Registered
Joined
·
221 Posts
its Metric thread i believe. I made a billet knob for mine. u can use a tap/die kit to identify the tread size.
 

·
Registered
Joined
·
7,381 Posts
I beleive it is a 10mm X 1.5 but don't quote me on that.....
 
1 - 6 of 6 Posts
Top