Can-Am Maverick Forum banner

Secondary clutch

5959 Views 4 Replies 2 Participants Last post by  ///AIRDAM
Sup guys, recently my belt broke and a new one just came in. I put the the new belt on and I backed out the spreader bolt and bam, the damn thing stayed open..pulled it off to find way in there it had pieces of belt stuff and keeping it from closing. And let me tell you, me and my bro went to pulling On the clutch and got nowhere fast. Set a lil lube inside and let soak.. Finally after pulling like crazy we got the secondary pulled apart. Cleaned it with brake cleaner and inside the sheeves I dabbed a a very tiny amount of oil just so the secondary will go back together since brake cleaner dried it out. Now my question is... The shaft that the secondary is put together by "shaft inside the clutch" I cleaned it wit brake cleaner, now do I need to grease this shaft b4 reassembly?
1 - 3 of 5 Posts
Good deal appreciate it.. The secondary wasn't closing cause it had some shavings from the old broke belt inside the clutch keeping it from closing..I cleaned it the best I could while the clutch was off... I pushed the clutch back together but it's takes a ill muscle to pull it back off the secondary supposed to be a ill tough to pull apart or are they supposed to just slide apart? 11 hours on machine no water.
Meant to say the sec. Clutch is still off and I hold it in my hands trying to take the clutch apart and it's a ill tough to take the face completely off
1 - 3 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.