Can-Am Maverick Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
221 Posts
Discussion Starter #1
My set up is Rage3 with gold spring and 40gram weights.
My secondary is set up 45degree helix no engine breaking and a gold spring and two shims.

It takes off at 2000rpm like i want but upon further acceleration it revs an barely goes. at 46mph im running around 7600rpm. I ordered the secondary with the yellow spring but it came with the gold spring stm said it would be better. I thing its to stiff. the primary is fine, if I was thinking about adding weight to the middle of the cam arms to lower the rpms but it think its deeper than that. HELP ! !!! :crying:
 

·
Registered
Joined
·
7,381 Posts
Shoot Nathan (nddodd) a PM and see what his setup is. He is running the same clutch setup except he has the EB helix in his secondary.
 

·
Registered
Joined
·
221 Posts
Discussion Starter #3
Ya i had ordered the EB HELIX with mine but they sent it with a non EB helix . Im fine with how it engine breaks now but im worried about the rpms still.
 
1 - 3 of 3 Posts
Top