Can-Am Maverick Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter #1
Hey guys.

I just finished a little project I had on the go. I was going to buy a Kolpin rear utility rack as pictured. And I though for what it's worth I might build my own. This project was really simple and depending on your Fabrication skills can look good. Mines really more rough and dirty but gets the job done. I over built it using 1.75" Dia. 1/8th wall DOM tuning welded some mounting brackets and used some Anzo light bar universal tube mounts for the roll cage attachment point. I installed Kolpin Rhino grip flex mounts 1.5" and 4" I believe.

Let me know what you guys think.


Sent from my CLT-L04 using Tapatalk
 

·
Registered
Joined
·
349 Posts
that works. form follows function and when you can save $$$$$ even better. nice.
 

·
Registered
Joined
·
57 Posts
Good idea Sortcan60, I like to fabricate some of my own parts also. Where did you get the role bar clamps from?
Thanks
 

·
Registered
Joined
·
59 Posts
Discussion Starter #4
Good idea Sortcan60, I like to fabricate some of my own parts also. Where did you get the role bar clamps from?
Thanks
The clamps are from prince's auto. They are light bar clamps. You can buy cheap universal mounts on Amazon

Sent from my CLT-L04 using Tapatalk
 
1 - 4 of 4 Posts
Top