Can-Am Maverick Forum banner
1 - 3 of 3 Posts

713 Posts
Discussion Starter · #1 ·
I pulled my QSC off a few minutes ago. I had to run to my buddies house and borrow his puller for his RZR 800 and it worked perfectly. I could not get that clutch off without that puller. Some side by side comparison. The STM is way heavier then the QSC. You can see the craftsmanship that goes into the STM.

Here is a pic of the clutch and puller.
Auto part Machine Rotor Disc brake Wheel

Auto part Disc brake Flange Rotor Machine

Technology Electronic device Audio equipment Small appliance

Small appliance Snare drum Machine Metal

Auto part
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.