Can-Am Maverick Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
175 Posts
Discussion Starter · #1 ·
I'm picking up a QSC from someone else who is going to an STM.

Anyway I spoken with Adam and he said it doesn't work to run it with the stock secondary because every time he has tried it the bolt has backed out and destroyed both clutches. I can get away with it at because I'm at higher altitude making less power.

He won't sell someone a QSC primary unless they buy an STM secondary as well.

He also said not to run a stronger secondary spring. What would you guys do?
 

·
Registered
Joined
·
175 Posts
Discussion Starter · #2 ·
Also can I use the factory primary bolt? I don't have clutch recall done yet. If not what do I need to get? Puller, bolt, etc?
 

·
Registered
Joined
·
175 Posts
Discussion Starter · #5 ·
Actually he recommended I run the stock secondary since I'm at higher altitude. I'll have better engine braking etc.

Does anyone have input on what all I need to install this?
 
1 - 3 of 3 Posts
Top