Can-Am Maverick Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
128 Posts
Discussion Starter · #1 ·
Hello all
Pick up a new 2014 XRS this Saturday from my dealer.
It's coming with BRP
Doors
Sport Aluminium roof
Rear bumper
Baja tyre carrier
Panoramic rear view mirror
Rear hitch
A arm protectors
Front lateral skid plates
Half windshield

Dealer has an STM rage 6 primary and secondary on order that will hopefully be fitted when it has it's 10hr service.
i have a set of 28/10/14 Bighorns that will be fitted to it as soon as its home...
 

·
Registered
Joined
·
128 Posts
Discussion Starter · #3 ·
Thanks
Been looking at lots of clutch posts and decided on the STM route, off to Morocco in March to help a mate run a rally out there so should be great fun in the sand.
 

·
Registered
Joined
·
128 Posts
Discussion Starter · #6 ·
Been looking at getting the bracing for the front but the shipping costs are nearly as much as the parts..
 

·
Registered
Joined
·
128 Posts
Discussion Starter · #15 ·
If you haven't done the front tie rods, I would highly recommend you do them as well. They are much more likely to break than the rears.....
I was going to get the Rackzilla steering rack but will hold off until Gearone have there's ready. I had the Rackzilla on my Commander and it developed a lot of wear in a short time....
 
1 - 8 of 8 Posts
Top