Can-Am Maverick Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
121 Posts
Discussion Starter #1
I found CT and Turnkey so far. I need it to hold a Viper widespool with 3x6.66 bolt pattern. Both say they can handle that bolt pattern but only CT says widespool in specs.

We ride on trails, woods and rocks.

I will have a Can am trunk in the rear so need it to work with that.

Any other bumpers to consider? Recommendations? Pic's of what you have installed?
 

·
Vendor
Joined
·
6,220 Posts
That bumper was built to hold Viper widespool and Warn winches. Widespool mounting is 3x6.66.
Front bumpers are in stock.
Our rear bumpers will have several different options and they will be ready in 2-3 weeks.
 

·
Registered
Joined
·
121 Posts
Discussion Starter #4
Thanks for the update Alex. I like your products. Can you post new pics of the rear bumper? Are they different than the ones posted on your vendor section post?
 

·
Vendor
Joined
·
6,220 Posts
This is our production roll cage as well. Rear bumpers can have a receiver, winch mount, tire carrier, mount under the bed or up to the cage.
 

·
Registered
Joined
·
175 Posts
Will the rear bumper and backbones work with the stock cage?
 

·
Vendor
Joined
·
6,220 Posts
Will the rear bumper and backbones work with the stock cage?
Yes. Since this got a full cage it's built into the cage. The rear bumper will tie into the stock cage.
 
1 - 10 of 10 Posts
Top