Here is some that I slapped together from a piece of rubber material that I think was a door mat not sure where it came from. They are 8" wide and stick out about 2" beyond the side of the Mav only had enough to make fronts. But they work good to keep stuff off. Still going to get Can Am ones when they are available. I just mounted to inner fender bolts and drilled one hole in the front below head light.
I also made a set of fender flares. They,re made from plastic that comes from dirt track race-car supply places (speedway motors or Day motor sports) I also ordered some large head aluminum rivets at the same time. Plastic comes 24" wide and you buy it by the foot length wise. Very durable and can be bent on a sheet metal break or even some patterns rolled into it with a bead roller. I think I ended up using less than 10' total.