Can-Am Maverick Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,159 Posts
Discussion Starter #1
We just made up some really heavy duty clutch pullers. The stockers tend to bend the tip really bad, after a few uses, & stubborn clutches.
Ours is made from premium 4140 material, heat treated to ~43RC hardness. The tip on ours is shorter, and a larger diameter to combat the tip bending, & machined in house, at MRRPM cycle.
They work really nice for people that pull the clutches often, like builders, maintenance guys, & dealers.

MRRPM Primary puller.jpg
 

·
Registered
Joined
·
1,159 Posts
Discussion Starter #2
Here is a pic comparing one to a stocker, a bent stocker at that. Notice the bigger diameter, & shorter length tip on the MRRPM one. These also feature a tighter tolerance on the threads, Price is $50.USD

MRRPM puller w stock.jpg
 
1 - 2 of 2 Posts
Top