Can-Am Maverick Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
227 Posts
Discussion Starter · #1 ·
I have been playing with my cage. Decided to go to 5 point harness, cut out seat belts. Cut out nets. Welded cage together, welded in harness bar, .050 chromoly. Welded in top supports, arched chromoly. Welded in light bar support/surround. Welded in dzus tabs for the aluminum roof. I made the roof by molding it with a aluminum auto body hammer. Forearms are feeling it. Bicycle part Wheel Tire Vehicle Chassis Table Furniture Chair Iron Metal Table Furniture Glass Metal Gas
 

·
Registered
Joined
·
4,535 Posts
nice , i did same thing front V bar to , i need to get net and seatbelt tabs off tho !
 

·
Registered
Joined
·
227 Posts
Discussion Starter · #3 ·
Nice. Can you still run a windshield with the v/intrusion bars?
 

·
Registered
Joined
·
4,535 Posts
oh ya it runs on top/across of the bars , it helps keep the windshield from flexing or wobbling and keeps it straight
 

·
Registered
Joined
·
227 Posts
Discussion Starter · #6 ·
����
 

·
Registered
Joined
·
403 Posts
Better put some support on those front bars. They're weak. Mine folded at 4 separate points in a simple rollover.
 

·
Registered
Joined
·
227 Posts
Discussion Starter · #8 ·
I build a chromoly bar that is removable. Good to know though!
 

·
Registered
Joined
·
227 Posts
Discussion Starter · #10 ·
I like it. Good job. I will put up Picts when mine is back together. Thanks for picture.
 
1 - 10 of 10 Posts
Top