Can-Am Maverick Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Rolled my X3 Max DS and now Check Engine light is on and in limp mode. Any way to reset ? Was told there is a Sensor between the rear seats that if broken can cause the car not to read the air intake properly. Any tips on repairing that sensor?
 

·
Registered
Joined
·
2,262 Posts
The only sensor between the seats is the seat belt sensor. Did you disconnect the battery yet?
 

·
Registered
Joined
·
548 Posts
The only sensor between the seats is the seat belt sensor. Did you disconnect the battery yet?
I had same thing happen to mine. I have no active faults but chk eng msg and lite. Had battery disconnected for a week. Still got lite and msg. Dont think disconnecting battery fixes anything?


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
548 Posts
There is a code for improper shutdown. And also for belt slippage. Im thinking that is wat caused my light. When i get home i am going to connect mine to my CANDOO tool and kno for sure. But if your shut down that will cause it


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
548 Posts
Also chk the hose that connect the wastegate to solinoid. For some reason the solinoid barb broke when i tipped over on side


Sent from my iPhone using Tapatalk
 
1 - 5 of 5 Posts
Top