Can-Am Maverick Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
202 Posts
Discussion Starter #1
I figured I would post these steps from the 2014 service manual for anyone that may come looking for it. I do not have a 2013 manual to see if it is the same procedure.

Maintenance Soon Message Manual Reset

1. Select PARK
2. Turn ignition switch to ON. Do NOT start engine.

NOTE:
Steps 3 through 9 must be completed within 5 seconds.

3. Press override button and HOLD.
4. Press and release brake pedal.
5. Release override button.
6. Press and release brake pedal.
7. Press override button and HOLD.
8. Press and release brake pedal.
9. Release override button.
10. Turn ignition switch to OFF.

NOTE:
Do not turn ignition switch to ON before the multifunction gauge turns off.
 

·
Registered
Joined
·
202 Posts
Discussion Starter #3
You're welcome.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
7,381 Posts
same for the 2013...
 

·
Registered
Joined
·
2,964 Posts
LOL the procedure takes some motor skills to get done. I had no problem at the 10 hour service, but the last time was aggravating to say the least. Many tries and a few choice words I gave up. I had my brother in law try it the other day ( I already had WAY too many beers), and after a dozen or so attempt he got it.:haha:
 

·
Registered
Joined
·
2,964 Posts
The difficulty increases exponentially as beer intake increases for me. My workaround is to clear the message before starting the service work, rather than afterwards...learned that trick on my own...lol
I will make a mental note. Do it BEFORE the barley pops start going down...lol
 
1 - 10 of 10 Posts
Top