Can-Am Maverick Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
354 Posts
Discussion Starter #1
I'm starting to do the clutch bolt recall and need to know what size tool is needed to take off the plug so I can put a backup on the crankshaft.......thanks.
 

·
Registered
Joined
·
7,381 Posts
14mm allen or a 14mm socket head bolt and 2 nuts locked to it as a homemade tool…..
 

·
Registered
Joined
·
7,381 Posts
you bet…..I knew only because I installed the recall stud this weekend. My QSC was out getting a 2 way bearing installed and I wanted to ride so I installed it. It worked fine. I rode the crap out of it and the clutch didn't slip at all. I marked it when I installed it and all of the lines were still lined up….the sheaves were also lined up so no slipping as some people tend to believe they are designed to do….
 
1 - 4 of 4 Posts
Top