Can-Am Maverick Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter #1
I made a new dash panel to hold more switches and gauges, i relocated the key and start button down in the bottom triangle of the dash (near your knee). Of course, i didnt realize the factory coil pack is right there. Would getting longer plug wires and moving that coil pack a little further in the dash effect anything?
 

·
Registered
Joined
·
532 Posts
I wouldn't think it would be a problem.
electricity flows (or electrons rather) at 186,000 miles per second - so adding a couple of inches probably won't make a difference.
 

·
Registered
Joined
·
7,381 Posts
not at all....just make sure to use high quality wire and make sure both ends are sealed good and are water tight......
 

·
Registered
Joined
·
1,103 Posts
There would be no change that was measurable by No means..you could move it to the car next to you and it would still run just as good :)

Sent from my SCH-I545 using Tapatalk
 
1 - 5 of 5 Posts
Top