Can-Am Maverick Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I just received the UTVinc dash bar and attempted to install it. It came with no installation instructions. Do I need to remove some of the plastics to install? Or do I need to manipulate the bar in a certain way to get it in place.

Thanks
 

·
Registered
Joined
·
4,536 Posts
should just bolt on simple - here is a dragon fire , I think there same or close




hju.jpg
 

·
Vendor
Joined
·
6,219 Posts
If the clamps are just like the one shown above i would take off the two plastic pieces and loosen the front part of the cage allowing it to spread apart while not talking the bolts all the way out. Wiggle it in and start tightening the clamps and the cage together to get it in place . You shouldn't have any issues doing it that way.
 

·
Vendor
Joined
·
6,219 Posts
I'm sorry UTVinc, I just saw where this was under your section. Didn't mean to jump the gun on this.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #5
Thanks for the info, I'll try removing the two plastic covers and loosening the front cage. I just didn't want to mar the cage putting this on.
 
1 - 5 of 5 Posts
Top