Can-Am Maverick Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
486 Posts
Discussion Starter #1
Any one have any pic to show me ct shocks by areed
I wna make sure I mount them correct and set the ride height . Thank u
 

·
Vendor
Joined
·
6,221 Posts
I'll post this info for everyone even though we spoke earlier.
Basic setup:
Preload being measured from the top of the gray shock body to the top of the upper adjuster ring.
Crossover ring being measured from the top of the threaded shock body to the bottom of the lower crossover ring.

Front preload - 1 7/8"
Front crossover - 6"
Rear preload - 1"
Rear crossover - 5"

Setups can vary drastically between the ride height you desire, the terrain and the style of riding. I don't have guys riding in the dunes running the same setup as a trail rider, nor do I have desert racers running the same setup as a east coast racer. Once this base setup has been ran please call me and give me some feedback so I can get the vehicle dialed in for your riding.
 
1 - 2 of 2 Posts
Top