Can-Am Maverick Forum banner

1 - 11 of 11 Posts

·
Banned
Joined
·
1,017 Posts
Discussion Starter #1
I tried over the weekend and they wont budge.
 

·
Banned
Joined
·
1,017 Posts
Discussion Starter #3
I was leaning towards just ripping them off but wanted to make sure I wasn't missing anything
 

·
Registered
Joined
·
538 Posts
i just broke them off and ground down the tab and used some touch up paint so it would not rust.i tried to drill out the rivet's but it didn't work very good.
 

·
Registered
Joined
·
367 Posts
^what they said^
 

·
Registered
Joined
·
286 Posts
If your trying to save them drill the rivets but you will need to hold the back of them with pliers or vice grips or they will just spin and end up melting the plastic.
 

·
Registered
Joined
·
103 Posts
Drill the rivets out. They come out pretty easily. Some channel locks will help.
 

·
Registered
Joined
·
244 Posts
hell how do you keep the little pieces of crap on? mine fell off not like they protected anything anyway
 

·
Registered
Joined
·
395 Posts
Angle your 3/16 drill bit instead of drilling straight, that spins the rivet worse. 30 degree angle and it will pop the head off right away. Then pull on your guard, it snaps around your a-arm.
 
1 - 11 of 11 Posts
Top