Can-Am Maverick Forum banner

1 - 20 of 81 Posts

·
Vendor
Joined
·
6,219 Posts
Discussion Starter #1
We've been running this setup on several Mavericks and we're ready to put it in production.
In this picture it shows the bumper being tied into the cage. This production bumper will actually connect to the frame under the bed similar to the factory BRP bumper.

$500 bare and $600 with powder. A 2x2 receiver can be added upon request.

ImageUploadedByTapatalk1381453295.434769.jpg
 

·
Registered
Joined
·
6,621 Posts
I like it. nice job AR
 

·
Registered
Joined
·
244 Posts
good looking rear bumper... where is you get the fender flairs?
 

·
Registered
Joined
·
395 Posts
All right Alex, Get off the Computer and start on my Rear Bumper with receiver. Thx, do you need me to come over and help you weld and get caught up?
 

·
Registered
Joined
·
7,381 Posts
We've been running this setup on several Mavericks and we're ready to put it in production.
In this picture it shows the bumper being tied into the cage. This production bumper will actually connect to the frame under the bed similar to the factory BRP bumper.

$500 bare and $600 with powder. A 2x2 receiver can be added upon request.
It's hard to tell from this pic, but does the bumper tie in to the roll cage?
He answers your question in the original posting....
 

·
Registered
Joined
·
7,381 Posts
1 - 20 of 81 Posts
Top