Can-Am Maverick Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
175 Posts
Discussion Starter #1
Went fairly smooth. It helps a lot to jack up the machine and take weight off the suspension (obviously).

I had to redrill one hole on the front plate. I actually just enlargened the hole with a 1/2 drill but and that worked. It definitely was not gonna fit without modifying though. Crazy these things are that much different from machine to machine. Can ams jigs mist have alight differences.

1511377_10152025566242338_1378776539_n.jpg

10156155_10152025566297338_1900154485_n.jpg

971631_10152025566337338_1506847694_n.jpg
 

Attachments

  • Like
Reactions: 07XLN and AReed

·
Registered
Joined
·
367 Posts
Alex's stuff is great and mine went on without any problems. I see you put his tie rods on too.
 
  • Like
Reactions: AReed

·
Banned
Joined
·
1,017 Posts
Looking good. Im hoping to do mine this weekend. This and my doors are the only thing I haven't installed yet. Just haven't had the time
 

·
Vendor
Joined
·
6,220 Posts
The third upper mount is fine mounted like that but they fit a little bit better if it was flipped upside down.
 

·
Registered
Joined
·
531 Posts
Those look really nice, need to place my order this week.
 

·
Registered
Joined
·
175 Posts
Discussion Starter #6
The third upper mount is fine mounted like that but they fit a little bit better if it was flipped upside down.
The one the radiator hose runs against? I was wondering which way it went. Are there instructions on your site or anywhere? I didn't see any.
 

·
Registered
Joined
·
25 Posts

·
Registered
Joined
·
153 Posts
It is the one between the upper arms. Like Alex said it will work both ways but clears the brake line a little better if turned up the other way.
 
1 - 8 of 8 Posts
Top