Can-Am Maverick Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
584 Posts
Discussion Starter #1
I made a mistake and ordered the wrong size hose for my catch can, I bought 1/2" hose and clamps instead of 5/8, I ended up adapting the new hose to the old hose at both ends, my thinking was the a 1/2" hose would be enough to vent the gases, but then I remembered drilling the T vent on my Honda 450s when adding the HRC kit so now I'm wondering if I might build excessive pressure due to the smaller vent hose.
Also brp used 5/8 for a reason

What are your thought?
 

·
Registered
Joined
·
230 Posts
Mine had slight kink in it for 300 miles and I don’t think it affected anything. I did shorten the hose to get the kink out. I would say you are fine. I am all stock though. The catch can really does it’s job as it does collect some goop.
 
1 - 2 of 2 Posts
Top