Can-Am Maverick Forum banner
1 - 7 of 21 Posts

· Premium Member
Joined
·
9,800 Posts
One note is I think the 2020 is known for cracking reluctor wheel. So if it is Crank shaft position sensor related that may be the issue. Just something to be aware.

I used a small USB camera on one in my group last month and saw the damaged reluctor to diagnose it.

Tim
 
  • Helpful
Reactions: OVRKLL.LAB

· Premium Member
Joined
·
9,800 Posts
you cant replace the reluctor
it comes on the flywheel
That statement is not true, you see you can replace the reluctor...when you do there's a flywheel attached to it...

Next time you run into an issue like this where you can't figure out to replace something, post up I'll help you figure it out...

Tim
 

· Premium Member
Joined
·
9,800 Posts
It's what the Crank sensor uses to tell the computer what position the crank shaft is.

So it's right under the sensor.

All computer controlled vehicles use something similar.

Tim
 

· Premium Member
Joined
·
9,800 Posts
hey Tim I just checked my sensor and it’s full of bad pinched marked even had some cable showing! Got the sensor ordered! Hopefully this dose it! You recommend me still checking the wheel? Car has 96 hours
If you have a small USB camera it can't hurt. If not I suspect the sensor is your trouble.

Tim
 
  • Like
Reactions: Rufus Rosso
1 - 7 of 21 Posts
Top