Calibrating speedo with tire and clutch changes?

2705 Views 5 Replies 5 Participants Last post by PLAY-DOH, Dec 4, 2013

killrb

Discussion Starter · Dec 4, 2013

So I was thinking about adding a little taller tire and clutch kit to my 2014 Maverick. But does anyone know how or if you can calibrate the speedo for these changes? I'm a newby at this so maybe I'm just not aware of something that would answer my question.

Brandon

Save

1 - 1 of 6 Posts

heavysledz

· #2 · Dec 4, 2013

Don't know if you can but if it is possible it would need to be. Dome. By the dealer using the BUD's system

2013 Maverick XRS
- CT Race Worx Front end gusset Set
- CT Race Worx Racing tie rods w/bump-steer spacers
- CT Race Worx Rear radius rods
- CT Race Worx Inner Fenders
- CT Race Worx Dual rate shock setup
- TurnKey harness bar
- TurnKey Baja Series Front Bumper
- TurnKey Nerf bars
- TurnKey Race Air Intake
- TurnKey Sport Doors
- TurnKey Sport Roof
- TurnKey Billet Shifter
- Pro Armor 3" 5-point harnesses
- Pro Armor Fire Extinguisher/Mount
- Arcticbomb Switchless sport low mod
- QSC Predator primary
- STM Gen II secondary
- SunPro gauges: oil pressure/water temp/voltage
- Alba Racing CVT temp gauge
- Doebeck Gen4 AFR+ Fuel Controller
- Full Interior Thermal barrier
- DEI exhaust wrap
- BRP rear view mirror
- BRP 2" receiver hitch
- BRP Cargo Net
- BRP fender flares
- SuperATV EZSteer power steering
- Full Muzzy Exhaust System
- Totron 6" Fog light bar
- Totron 6" Backup LED Light
- Totron 42" LED Light Bar
- EVO Stage IV reflash

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month