Can-Am Maverick Forum banner

1 - 17 of 17 Posts

·
Registered
Joined
·
156 Posts
I used stainless steel clamps (similar to the ones on the previous post) from Grainger's. Bought a box of ten and used only eight. I also used stainless steel screws and washers from ACE Hardware.
 

·
Registered
Joined
·
256 Posts
Discussion Starter #7
Sorry finally getting my ass in gear. I am looing to order these here: Unsure should I get the 2" or 2 1/4" to fit the cage of the maverick since they have the rubber coating and look to be measured outside diameter. Any input would be great, I do like that I can get these in stainless so no rusting


http://www.mcmaster.com/#pipe-routing-clamps/=ryr8cg
 

·
Registered
Joined
·
251 Posts

·
Registered
Joined
·
251 Posts
I got the 2 bolts in the front through the gussets on the cage, and 3 clamps across the back. No rattles and no worries about it blowing off


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
256 Posts
Discussion Starter #16
Thanks guys just ordered them! Kinda pissed they have a location 15 mins from me but I can't actually go there and buy.
 

·
Registered
Joined
·
256 Posts
Discussion Starter #17
Just received them today, they sure do look small but I'm trusting you guys! lol Can't wait to pick the maverick up from the dealer.
 
1 - 17 of 17 Posts
Top