Can-Am Maverick Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
545 Posts
Discussion Starter #1
Spent all day designing and fabbing up doors. After several failed designs and wasted tube, finally came up with a workable design. These serve as side impact protection as well as suicide doors.

Still need to fab latchs and skins.
I can appreciate all the work that vendors go thru to build doors.
 

·
Registered
Joined
·
4,536 Posts
looks good !
 

·
Registered
Joined
·
1,685 Posts
Nice job. Yea fabrication is a lot of work, especially the Prototype. Curious why you did not have them open from the rear considering you had the option.
 

·
Registered
Joined
·
545 Posts
Discussion Starter #4
Nice job. Yea fabrication is a lot of work, especially the Prototype. Curious why you did not have them open from the rear considering you had the option.
It was a consideration, but wanted the doors and frames to also serve as side protection. It was easier to double latch it at the front than the rear. The lower door frame will tie into the center cross member for strength.
 
1 - 4 of 4 Posts
Top