Can-Am Maverick Forum banner

1 - 10 of 10 Posts

·
Premium Member
Joined
·
8,276 Posts
Discussion Starter #1
i am thinking about drilling out the rivets on the silencers and see if i can get more flow out of them.

I am even thinking of cutting open the y looking thing to see whats inside and remove the restrictions.
 

·
Registered
Joined
·
217 Posts
I dont think id do that unless u have a programmer you will prob throw a code and put it in limp home mode dealer told me today re mapping programmers are already made but wasnt for sure what company it is
 

·
Registered
Joined
·
998 Posts
I haven't seen the exhaust set up up close but does it have sensors pre or post converter? I was hoping or afr sensors pre cat so no codes would be thrown
 

·
Registered
Joined
·
1,272 Posts
1 of the video's that are out of the mav, said that its setup that if you change exhaust and things the computer is set to handle it,,,they said u wont need a programmer.
 

·
Registered
Joined
·
998 Posts
If the sensors are pre cat then we should be fine. No sensors after the cat means no way the computer can detect if its there or not.
 

·
Premium Member
Joined
·
8,276 Posts
Discussion Starter #10
i had to promise my wife i would not chop this one up like my last 3 sxs's.

modifications will start as soon as the wife turns her head and forgets about how much i just spent.
 
1 - 10 of 10 Posts
Top