Can-Am Maverick Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
I am curious what I will need to do for the driver seat belt bypass. I have not yet looked at it. I am assuming I can probably just connect two wires together to bypass the system that makes you have seat belt buckled to go over 10mph. Anybody done this yet? If not, I guess I will find out later this week when my stuff gets here.
 

·
Registered
Joined
·
6,621 Posts
Yep, I just cut the wire, then put wires together using a wire nut. Wrapped electrical tape around it to secure wire nut. Worked perfect.
 

·
Registered
Joined
·
48 Posts
Discussion Starter #3
Yep, I just cut the wire, then put wires together using a wire nut. Wrapped electrical tape around it to secure wire nut. Worked perfect.
Cool, thanks. That's what I was thinking, but figured I would ask before I monkey with it.
 

·
Registered
Joined
·
6,621 Posts
It's super easy, once you remove all the plastics. I also welded in tabs in the front below the seats for the 5pt strap.
 
1 - 4 of 4 Posts
Top