Can-Am Maverick Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
227 Posts
Discussion Starter #1
I spent some time on the lathe last week. Stupid me, I did not measure the wickidbuilt tie rods that are on my machine. So I have a set of stock length tie rods for sale. They are 1" solid billet aluminum, never even mounted. I am thinking about 60.00! Thanks. image.jpg
 

·
Registered
Joined
·
67 Posts
ill take them if u take paypal and want to ship them and its not to expensive
 

·
Registered
Joined
·
227 Posts
Discussion Starter #3
ill take them if u take paypal and want to ship them and its not to expensive
Sure. Give me your address and email for PayPal. I can ship tomorrow.
 

·
Registered
Joined
·
67 Posts
I pmed u
 

·
Registered
Joined
·
88 Posts
will they fit the xmr
 

·
Registered
Joined
·
227 Posts
Discussion Starter #6

·
Registered
Joined
·
244 Posts
any thought to making any for the rear? I like to buy local
 

·
Registered
Joined
·
227 Posts
Discussion Starter #8
any thought to making any for the rear? I like to buy local
I can do that. They would have heims in the inside though. Let me figure them out. Thanks.
 
1 - 8 of 8 Posts
Top