Can-Am Maverick Forum banner
1 - 1 of 1 Posts

· Registered
7 Posts
Discussion Starter · #1 ·
I have some extra solid aluminum stock that is 6061/t6 grade. I have cut them to 12 3/16. The diameter is 7/8. A half inch hole will need to be drilled and then a tap 14mm 1.5 pitch for the tie rods. Asking $30 plus shipping for the pair of rods which will make a set of tie rods. This is a cheap way to make a back up set of tie rods for the maverick. Thanks Andrew [email protected] will accept paypal


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.