Can-Am Maverick Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter #1
Hi all,

Finally getting around to installing my EVO charge tubes/BOV and Alba boost gauge.

Have everything installed but can't get a reading off the boost gauge. Stays at 0.

Tried revving the engine up in park but the gauge doesn't move. I can hear what sounds like the BOV going off, or the wastegate, not sure.

Anyone run into this issue or have to adjust the spring on the BOV from EVO?

Any insights would be greatly appreciated. Heading for a weekend riding trip on Friday and would like to get this figured out.

Attached a pic showing where i tied into the port, and how its split for the BOV and boost gauge.

Mods are stock flash, evo charge tubes, cat delete and slip on exhaust.

Thanks.

BOV.jpg
 
1 - 2 of 2 Posts
Top