Can-Am Maverick Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I have a set of Hiper Sidewinder duel beadlocks fitted with the Pitbul Growlers and I'm having to pull them apart to clean sand out of the beadlock because they are causing air loss. Is this typical? I sure hope not with the cost of them. Any suggestions?
 

·
Registered
Joined
·
4,536 Posts
make sure there clean when they mounted the tires,

and keep the bolts on the beadlocks tight evey other ride ,

from what i hear this helps !
 

·
Registered
Joined
·
4,536 Posts
were they all tight the bolts?
 

·
Premium Member
Joined
·
8,276 Posts
all correct torque. I'm thinking might user a bit of silicone on the bead ring
you will regret using silicone when you change tires. Figure out where and why its leaking first, remove the tire and rotate it 90* on the wheel. air it up to 15psi and use dish soap and water in a spray bottle to find it.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #8
you will regret using silicone when you change tires. Figure out where and why its leaking first, remove the tire and rotate it 90* on the wheel. air it up to 15psi and use dish soap and water in a spray bottle to find it.
its sand thats getting between the beadlock ring and the tire
 

·
Registered
Joined
·
1,103 Posts
Having trouble with my stock front left tire. After yesterdays ride, 3rd time. Keeps getting dust, dirt, sand under beadlock. I am taking it in today. Must have a problem with a ring not completely true. That is all that I can figure....
 
1 - 9 of 9 Posts
Top