Can-Am Maverick Forum banner

1 - 1 of 1 Posts

·
Registered
2014 Maverick 1000r XXC
Joined
·
3 Posts
Discussion Starter #1
So I put a Dalton clutch kit in my 14 Mav 1000r and replaced the secondary stud (which really wasn't necessary I was just playing it safe, however I was having a hard time getting it tourqed without can ams counter shaft holder, my question is, would I be easier to tourqe the stud with the sheves on and the clutch holder then tourqe the nuts or take the sheves off and use a screwdriver in the helix or something to keep that countershaft from spinning lol wisgi did a little more research before diving in, everything's buttoned up but I want to revisit before I ride to make sure that stud is tourqed so my secondary doesn't install a window in my ass
 
1 - 1 of 1 Posts
Top