Can-Am Maverick Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. Member Introduction
    Hi I have a 2017 Maverick X3 XDS Turbo R. The Ryco moto turn signal kit was fully installed and working then I went on a ride… it stopped working. I have no brake lights, no running lights in the rear and no license plate light. I do have rear turn signals and everything else works as well. I...
  2. Maverick Discussions
    Hi all, I need some help wiring up a 3 way on-off-on 7 pin rocker switch. I currently have a 40" light bar on the roof but want to lighted side mirrors. I want to wire it so that the mirror lights are on one position, and then both on, on the other position. My problem and question: Do I need...
  3. Member Introduction
    Hi, first post here, signed up just to ask this question, but Im needing some help with my audio roof. I've had the Can am Audio roof for a few months now and I am ready to install some new mods, 3 things on my list are new Baja Designs lights. On the roof, by the head unit, there are 3...
  4. Maverick Trail, Sport, (Gen2) Commander
    Looking for some guidance / direction. I'm going to be adding a USB charger port to my MavT to give power to my GPS as it likes to eat batteries (Garmin GPSMAP 66ST) and also give me better charging than the standard 12V. I've included the mount location picture where the GPS Ram mount is...
  5. Audio, Lighting and Electrical
    I have an X3 Max with a street legal kit with turn signals already installed. It uses the three small amber LEDs for the left/right signal. The amber lights are always on when the headlights are on. My signature light kit (that I'm in the process of installing since my machine didn't come...
  6. Maverick Accessories
    Hi all, I need some help wiring up a 3 way on-off-on 7 pin rocker switch. I currently have a 40" light bar on the roof but want to add pods on the sides and a shock tower light. I want to wire it so that the shock and pods are on one throw and then everything on on the other throw. I know how...
  7. Maverick Trail, Sport, (Gen2) Commander
    Hey team, I am at a loss on this. The wiring diagram for my Sport XRC shows JB1, a 3 screw terminal block under the dash, and specifically terminal 3 POST_ACC as the 12VDC supply to, I would imagine, add on accessories. The color code of the wire that feeds this terminal, W453, is purple (not...
  8. Maverick Trail, Sport, (Gen2) Commander
    I am curious about a couple of items in the wiring. Behind the dash center there are at least two connectors just hanging there, one on a very short set of wires obviously intended for another rocker switch for the last empty rocker slot and is the green one in the first photo and is actually...
  9. Member Introduction
    Does anyone have a schematic for a 2019 Maverick Sport XRC? Is it in a service manual? I am curious about a couple of items in the wiring. Behind the dash center there are at least two connectors just hanging there, one on a very short set of wires obviously intended for another rocker switch...
  10. Maverick Trail, Sport, (Gen2) Commander
    Anyone have any experience with the overhead switch panel? I am looking to install a roof light bar, a dome light. If i did not put the overhead panel I would have to run a 12V for each light connected to separate switches, along with ground to both of them. The light bar is 12awg wire and the...
  11. Maverick 15-16 XDS/XRS Turbo
    There has got to already be a thread on this. I cant find it. I'm looking to wire my LED bars to my brights. OUTLAW LED makes a wiring harness that supports a 40 inch a and two others. I need their wiring harness and not the light bars. Has any one been sucessful building their own or...
  12. Maverick Accessories
    Has anyone changes the glow color of the OEM rocker Switches from red to a different color?
1-12 of 12 Results
Top